Step 1

Clean hands with soap and water or hand sanitizer.

 Step 2

Remove a single ClearMask™ Transparent Face Mask from packaging and peel off the protective layer on the outward-facing side of the mask. Inspect for any damages, rips, holes or contamination. Do not use product if any damages or contamination are found.

Step 3

Position the mask in your hand with the foam facing inward and the nose cutout on top, towards your fingertips. Bring the mask towards your face, such that your nose fits into the nose cutout and your chin rests on the bottom foam piece.

Step 4

With your other hand, take both the top and bottom straps and pull them over your head. The bottom strap sits around the base of the head, below the ears. The top strap rests higher at the back of the head, above the ears. Do not crisscross straps.

Step 5

Use the EZ-Adjuster in the back to adjust the mask by pushing inward to tighten or pulling outward to loosen the straps.

Step 6

Ensure proper fit and direct contact between the face and the foam with minimal gaps. Please exercise caution when signing or gesturing to avoid contact or scratches with the edges of the mask.

Step 1

Clean hands with soap and water or hand sanitizer.

Step 2

Remove the ClearMask™ Transparent Face Mask by pulling the straps up and over the head, loosening the adjuster piece if needed.

Step 3

Slowly pull the mask away from the face. Avoid touching the front of the mask or any liquid splatter on the mask.

Step 4

Dispose of the mask according to local biohazard safety regulations.